Bird Feeder Compatible with Blink Outdoor 3 and 4

Set up a closer view of visiting birds with a feeder designed to hold a compatible Blink camera.

The compact feeder has a curved roof, open tray and rear camera position. This listing is for the physical feeder only; the camera and any camera service are not included.

Product details

• Designed by Pascal for Blink Outdoor 3 and 4 cameras
• Camera, batteries and subscription not included
• Camera framing depends on installation and camera settings

Materials and making

Each piece is 3D printed, post processed, assembled and UV clear coated by Custom Crafting Alliance in the United States. Made from High-Quality PLA with an exterior UV clear coat.

Before ordering

One finished bird feeder is included. Your piece is made after you order.

Care and placement

Place in a shaded or sheltered location and avoid excessive heat or prolonged direct sunlight. PLA can soften in high heat; a UV clear coat does not make it heatproof. Clean gently and inspect regularly. Reapply a suitable UV-protective clear coat to exterior surfaces as needed, following the coating manufacturer's directions and allowing it to fully cure before use. Keep the feeding area clean and dry, remove spoiled seed promptly and clean before refilling. Birdseed is not included.

About the photographs

Catalog photographs are used with the designer's permission to show the design. Minor color and surface variations are part of the 3D-printing process.

3D printed by Custom Crafting Alliance from a 3D model licensed from PA1_MAKER.

Make it yours

Check your Blink model, then build your own bird watching setup around this feeder.